Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-132 Issue 4 May 2002
enable mst
Enables the message trace that is controlled according to the parameters created
with the change mst command. If executed while the trace is enabled, the
command has no effect and returns a screen message indicating that the
command was successful.
enable suspend-alm-orig
This command enables Suspend Alarm Origination for a board (including all ports
and endpoints on the board) or for a port (including all endpoints on the port) for
both on- and off-board alarms or for off-board alarms only. Many control circuit
packs do not have a board location, so this command cannot support all circuit
packs. Each enable command becomes a new entry or replaces an existing entry
in the Suspend Alarm Origination table. A new entry that matches both the
physical location and off-only, on-, and off-board specifications of an active entry
replaces the active entry in the Suspend Alarm Origination table.
This command may be particularly useful for:
■ Improved control over customer requests. For example, to suspend
off-board DS1 alarms temporarily for customers who periodically
disconnect DS1 trunks for testing or other business-related purposes.
■ Improved control over external (non-Avaya) problems such as suspending
off-board DS1 alarms before a customer resolves facility problems (for
example, a T1 trunk that has developed an off-board condition).
■ Improved control over internal (Avaya) problems that cannot be resolved
immediately. For example, the command can be used to suspend Alarm
Origination for a bad circuit pack detected late Friday night when dispatch
personnel cannot respond until Monday.
NOTE:
Also see other Suspend Alarm Origination related commands, including
disable suspend-alm-orig and list suspend-alm-orig.
Action/Object Qualifier Qualifier Description Logins Defaults
Feature
Interactions
enable mst init
inads
none none
To Next Page
Loading...
