test pkt
Issue 4 May 2002
A-137 555-233-123
Error Messages
If this command is executed on the standby SPE and this SPE is busy at the
moment, the following appears:
Standby SPE busy;
See status system for more details
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
test pkt
Help Messages
If the system technician presses HELP after entering “test pkt” the following
message appears:
Enter ’port-network’, port network number (1-3),
[’long’ or ’short’], [’repeat’ (1-100)
or ’clear’], [’schedule’]
Error Messages
If the technician does not enter all digits for the port-network number, the following
message appears:
Entry must be all digits
If the port network on which the desired Packet bus resides is unavailable, the
following message appears:
EPN is not available
For any system, if the length of the user entered parameter “port network”
exceeds 3 the following message appears:
Entry invalid
If the packet bus is not activated the following message appears:
Packet Bus is not activated,
check system-parameters maintenance form
If no tests can be found for the associated MO, the following message appears:
No tests for this MO
To Next Page
Loading...
