resume hardware-group
Issue 4 May 2002
A-81 555-233-123
If the NETCON data module is not administered or out of service the following
message appears:
Required NETCON data module not
administered or out-of-service
If the NETCON data module is busy the following message appears:
Required NETCON data module unavailable
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
resume hardware-group
Help Messages
If the system technician presses HELP after entering “resume hardware-group,” the
following message appears:
Entry is not required
Error Messages
If there is no “test hardware-group” command to be resumed, i.e, no “test
hardware-group” command was previously canceled, or some system recovery
had occurred and no “test hardware-group” command had since been entered
and subsequently canceled, then the following message appears:
Command aborted - no hardware-group
test available to resume
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If the previously entered hardware-group command used the “all-ports” option the
following message appears:
Resume disallowed with ’all-ports’
option in original command
If the previously entered hardware-group command used the “SPE-interchange”
option the following message appears:
Resume disallowed with ’SPE-interchange’
option in original command
To Next Page
