Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-100 Issue 4 May 2002
status interface
Help Messages
If the system technician presses HELP after entering “status interface”, the
following message appears:
Enter location: [cabinet(1)], carrier (A-B),
position(1-2); [’print’]
Error Messages
If the specified carrier is not the active PE, the following message appears:
Port invalid
If the technician-entered cabinet and carrier is invalid for a PPN, the following
message appears:
Entry is bad
If the technician-entered carrier is not a valid carrier, the following message
appears:
Invalid carrier specified
If the technician-entered carrier is not active, the following error message will be
entered:
Board invalid
If the specified carrier/position processor interface circuit pack is not inserted, but
the specified carrier is active, the following error message appears:
Processor Interface (TN765) not
started or is being started
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
To Next Page
Loading...
