Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-96 Issue 4 May 2002
Error Messages
If the format of the port location is incorrect, the following message appears:
Port/Board invalid
If the port location entered is not between 5 and 7 characters long, the following
message appears:
Port invalid
If the port is not administered, the following message appears:
Port not assigned
If the board associated with the entered port location is not inserted, the following
message appears:
Board not inserted
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
status card-mem
Help Messages
If the system technician presses HELP after entering “status card-mem,” the
following message appears for a duplex system:
Enter [cabinet(1)];carrier(A-B), [’print’]
[’print’]
Error Messages
If the carrier entered is invalid, the following message appears:
“entered value” is an invalid identifier;
press RETURN to execute modified command
If the NETCON board is not TN777B, then the following message appears:
Must install TN777B circuit pack
To Next Page
Loading...
