Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-132 Issue 4 May 2002
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
test maintenance
Help Messages
If the system technician presses HELP after entering “test maintenance”, the
following message appears:
Enter [cabinet(2-3)];carrier(A)],
[’long’ or ’short’], [’repeat’(1-100)
or ’clear’], [’schedule’]
Error Messages
For any system, if the entered value is invalid, the following message appears:
Identifier invalid
If the port network specified is not available, the following message appears:
EPN is not available
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
test memory
Help Messages
If the system technician presses HELP after entering “test memory” on a simplex
SPE system the following message appears:
Enter [cabinet(1)];carrier(A),
[’long’ or ’short’], [’repeat’ (1-100)
or ’clear’], [’schedule’]
To Next Page
Loading...
