Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-90 Issue 4 May 2002
Field Error Messages
Following are the error messages that appears on the bottom of the screen. The
messages are displayed when the system technician tabs out of a field and the
validation routines are executed.
set tone-clock
Help Messages
If you press HELP after entering “set tone-clock,” the following message displays:
Enter tone/clock location:
[cabinet(1-3)];(carrier(A-E)) [’override’]
Error Messages
If an identifier greater than 3 characters is entered, or the cabinet entered is not a
digit (number), the following message appears:
Identifier invalid
If the carrier entered is invalid, the following message appears:
Invalid carrier specified
If the cabinet entered is not within the valid range of cabinets or the cabinet is not
administered, the following message appears:
Cabinet number not assigned
If there is no tone/clock board at the specified location, one of the following
messages appears:
Board not inserted
Board not assigned
Hour: "Enter number between 0-23"
Minute: "Enter number between 0-59"
Second: This field is restricted and consequently the system technician cannot tab to
or change this value.
Day of the Week: “”xxxxxx” is an invalid entry; please press HELP”
Day of the Month: "Day invalid"
Month: “”xxxx” is an invalid entry; please press
HELP”
Year: "Year invalid"
Hour: "Hour invalid"
Minute: "Minute invalid"
To Next Page
Loading...
