release link
Issue 4 May 2002
A-65 555-233-123
release link
Help Messages
If the system technician presses HELP after entering “release link,” the following
message appears:
Enter 1 character link number
Error Messages
If the link identifier is not valid, the following error message appears:
Link out of range, please press
HELP
If the link is not administered, the following error message appears:
Link not administered or not enabled
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then
resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
release mis
Help Messages
If the system technician presses HELP after entering “release mis” the following
message appears:
Entry is not required
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
To Next Page
Loading...
