set synchronization
Issue 4 May 2002
A-87 555-233-123
Error Messages
If the specified group identifier is non numeric or out of range, the following
message appears:
Signaling group invalid
If the specified group identifier is not administered, the following message
appears:
No signaling group assigned
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
set synchronization
Help Messages
If the system technician presses HELP after entering “set synchronization,” the
following message appears:
Enter DS1 board location or Tone-Clock location:
[(cabinet (1-3)]; carrier (A-E))
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
Can not set synchronization to standby tone clock circuit pack.
Cannot set synchronization to standby tone/clock board.
To Next Page
Loading...
