Maintenance Object Repair Procedures
555-233-123
10-880 Issue 4 May 2002
H323-STN (H.323 IP Station)
This maintenance object covers implementation of the maintenance for native
mode H.323 endpoints. Native mode H.323 applications such as NetMeeting or
Proshare only provide what is needed to support the H.323 standard. There is
very little that DEFINITY can invoke in the maintenance area. DEFINITY will
report errors as they are detected via the RAS registration and keep-alive
mechanism. DEFINITY will PING the endpoint both via the signaling path (i.e. via
C-LAN) and via the media path (i.e. via Medpro).
This station type is not attached to a port board. Insertion of the station is not
driven by board insertion, rather it is driven by successful registration of the
endpoint. It is maintained via a set of explicit TCP/IP ping requests and errors
reported by the switch software, which terminates the H.323 signaling portion of
each endpoint. The MO follows standard maintenance methodology and supports
test, busyout, release and status commands.
Error Log Entries and Test to Clear Values
Notes:
a. Error Type 1: this error reports the registration status of the endpoint. If call
processing SW claims the endpoint is registered and receives keep-alive
handshakes from the endpoint, the test passes. If keep-alive handshaking
has failed, the test fails. If the user has intentionally un-registered from
DEFINITY, the station is now basically an AWOH station and is no longer
being maintained; no tests will run for this station.
MO Name (in
Alarm Log) Alarm Level
Initial Command to
Run Full Name of MO
H323-STN WARNING test station extension H.323 IP Station
Table 10-318. H323-STN IP Station Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0 0 Any Any test station extension
1 (a) Registration Status Inquiry
Test (#1372)
WARNING OFF
257 (b) Signaling Path PING Test
(#1373)
WARNING OFF
513(c) Media Path PING Test
(#1374)
WARNING OFF
To Next Page
Loading...
