Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-400 Issue 4 May 2002
status trunk
status trunk group# [/ member#] [print]
The status trunk command displays information about the operational status of a
single trunk or of all members of a trunk group. You can also use it to locate
facilities with which the trunk is communicating.
The monitor trunk command displays the same information and updates the
screen automatically every minute or on demand.
Parameters
Examples
status trunk 78
status trunk 80/2 print
group#/
member#
If you enter a trunk group number without a member number, the
information for all members of that group appears as shown in the
second screen shown below. If you enter a trunk group and a member
number separated by a slash (/), then information for only that member,
including some additional fields, appears as shown in the first screen
shown below. If you enter a group number followed by a slash (/), the
system defaults to member number 1 and displays the member report.
To Next Page
Loading...
