Maintenance Object Repair Procedures
555-233-123
10-2 Issue 4 May 2002
Cabling Precautions
!
CAUTION:
Do not cut or bend fiber optic cables. Doing so may adversely affect
communication between the EPN and the PP N cabinets.
!
CAUTION:
To avoid damaging the cable-to-connector interface when removing any
Inter-Carrier Cable, grasp the cable connector, not the cable itself.
ABRI-PORT (ASAI ISDN-BRI Port)
NOTE:
Refer to “BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI
Port)” for repair procedures.
MO Name (in
Alarm Log) Alarm Level Initial Command to Run
1
1 Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier designation (A,
B, C, D, or E); and SS is the address of the slot in the carrier where the circuit pack is located (01,
02, and so forth); and pp is the 2-digit port number (for example, 01).
Full Name of MO
ABRI-PORT
2
2 The alarm level for ABRI ports may be administered using the set options command. The alarm
level can be set independently for Off-Board and On-Board alarms to MAJOR for all ABRI ports in
the system.
MAJOR(b) test port PCSSpp l ASAI ISDN-BRI Port
ABRI-PORT MINOR test port PCSSpp l ASAI ISDN-BRI Port
To Next Page
Loading...
