Avaya Definity SI - Memory; MIS (Management Information System)

MEMORY
Issue 4 May 2002
10-1095555-233-123
MEMORY
Refer to MEM-BD (Memory Circuit Pack) for circuit pack level errors.
MIS (Management Information
System)
Management Information System (MIS)/Call Management System (CMS) MO is
used for administering MIS translations, such as trunks and stations. There are no
hardware failures associated with this MO.
To diagnose MIS link hardware errors and alarms, see PI-LINK (Processor
Interface Link) and PI-SCI (System Communication Interface) maintenance
information.
MIS/CMS is an adjunct processor that collects ACD data sent from the system. To
change MIS translations, enter busyout mis at the terminal. When the MIS is
busied out, the system stops sending ACD data to the MIS, and a Warning alarm
is raised. When finished, enter release mis. This clears the Warning alarm and
allows the switch to send ACD data to the MIS.
Error Log Entries and Test to Clear Values
Note:
a. When busyout MIS is issued, no data is sent to the MIS/CMS. To allow
data to be sent to MIS/CMS, issue release mis from the terminal.
MO Name (in
Alarm Log)
Alarm
Level Initial Command to Run Full Name of MO
MEMORY MAJOR test memory a/b l c memory
MO Name (in
Alarm Log
Alarm
Level
Initial Command
to Run Full Name of MO
MIS WRN release mis Management Information System
Management Information System Error Log Entries
Error Type Aux Data Associated Test Alarm Level
On/Off
Board Test to Clear Value
0
1
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence.
0 Any Any Any release mis
18(a) 0 busyout mis WARNING ON release mis