Maintenance Object Repair Procedures
555-233-123
10-1144 Issue 4 May 2002
M/T-BD (Maintenance/Test Circuit
Pack)
!
CAUTION:
In G3iV1.1-286 and G3iV2-386, a TN771D (or later vintage)
Maintenance/Test circuit pack must be used.
Refer to XXX-BD (Common Port Circuit Pack) Maintenance documentation for
circuit pack level errors. See also M/T-DIG (Maintenance/Test Digital Port) and
M/T-PKT (Maintenance/Test Packet Bus Port) Maintenance documentation for
related digital port and Packet Bus port information, respectively.
MO Name (in
Alarm Log)
Alarm
Level
Initial Command to
Run
1
1 Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier
designation (for example, A, B, C, D, or E); and SS is the address of the slot in the carrier
where the circuit pack is located (for example, 01, 02, ..., etc.).
Full Name of MO
M/T-BD MIN test board PCSS l Maintenance Test Circuit Pack
M/T-BD WRN release board PCSS Maintenance/Test Circuit Pack
To Next Page
Loading...
