Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-80 Issue 4 May 2002
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If this command is issued while an upgrade software command is active the
following message appears:
Standby SPE upgrade in progress, command denied
restore announcements
Help Messages
If the system technician presses HELP after entering “restore announcements,” the
following message appears:
Enter [’print’ or ’schedule’]
Error Messages
If the announcement data module cannot be accessed (upload/download port is
active), the following message appears:
Announcement data module not available
If the announcement data module has been taken out of service, the following
message appears:
Announcement data module out of service
If one or more of the announcement ports are in use, the following message
appears:
Announcement port in use; please try later
If the announcement data module is not administered, the following message
appears:
Required announcement data module not administered
If the announcement data module is not administered or is currently in use, the
following message appears:
Required data module not administered or unavailable
If there is no announcement board in the system, the following message appears:
Integrated announcement board not present
To Next Page
Loading...
