list trace
Issue 4 May 2002
8-219555-233-123
list trace
Use this command to troubleshoot misdirected calls, trunking/routing problems,
and call denials. This command allows you to view the Virtual Path Identifier (VPI)
and Virtual Channel Identifier (VCI) data, adding either of these qualifiers:
■ list trace station
■ list trace tac
list trace station
Use this command to check the VPI.VCI data for a specified station (list trace
station extension). The command syntax for ATM-specific trace data is:
list trace station xxxxx/a where xxxxx is the station number, and /a
means that you are requesting ATM-specific data.
Screen 8-16 shows VPI.VCI data for a successful 2-party call setup. Use the Field
descriptions (list trace) to interpret this report.
Trunks Failed
Marginal
Threshld
The number of trunks that failed a marginal threshold, but not an
unacceptable threshold according to the threshold values defined
on the trunk group form.
Trunks Failed
Unaccept
Threshld
This is taken from the unacceptable threshold administered on the
Trunk group form.
Trks In-Use
The number of trunks that were in-use at the time of testing.
Trks Not Test
The number of trunks that were not tested due to error conditions.
Busied Out
Trunks
The number of trunks that were busied out at the time. This could
be due to hardware problems, incorrect threshold values, etc.
Action/Object Qualifier Qualifier Description Logins Default
Feature
Interactions
list trace station
tac
VPI.VCI data for a specific station
VPI.VCI data for a specific
trunk/member
init
inads
craft
customer
To Next Page
Loading...
