Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-34 Issue 4 May 2002
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If the update file is too large to fit on device, the following message appears:
Update file is too large to fit on device
If the checksum of the files is not correct, the following message appears:
Update file checksum failed
If the update is successful the following message appears:
Command completed successfully
disable administered-connection
Help Messages
If the user presses HELP after entering “disable administered-connection,” the
following message appears:
Enter assigned administered connection number(1-128) or ’all’
Error Messages
If the administered connection number entered is not “all” and is non numeric, the
following message appears:
Identifier invalid
If the administered connection number entered is not within the valid range of
connections, the following message appears:
Entry out of range
If the connection number entered is not administered, the following message
appears:
Identifier not assigned
If the administered connection number entered is already disabled, the following
message appears:
Administered connection already disabled
If the software data cannot be sent to the SAT, the following message appears:
Error encountered, can’t complete request
To Next Page
Loading...
