Avaya Definity SI - Reset System

reset system
Issue 4 May 2002
A-79 555-233-123
Error Messages
If the specified level is invalid (not 1-5), the following message appears:
System reset level invalid
If the standby SPE is not refreshed and the SPE Select switches are selecting the
active SPE, the following message appears:
Active SPE locked via select switches;
Standby SPE memory not refreshed
If the standby SPE is not refreshed; the following message appears:
Standby SPE memory not refreshed; use the
“refresh spe-standby” command
reset system
Help Messages
If the system technician presses HELP after entering “reset system” on a simplex
SPE system, the following message appears:
Enter system recovery level ’1’(WARM), ’2’(COLDII),
’3’(COLDI), ’4’(REBOOT), or ’5’(EXT REBOOT)
If the system technician presses
HELP after entering “reset system” on a duplex
SPE system, the following message appears:
Enter system recovery level ’1’(WARM), ’2’(COLDII),
’3’(COLDI), ’4’(REBOOT), or ’5’(EXT REBOOT)
or ’interchange [’health-override’]’
Error Messages
If the CANCEL key is pressed after the command has been started, the following
message appears:
This command may not be canceled
If the system reset level is not numeric or “interchange,” the following message
appears:
System reset level invalid
If the “health-override” option is specified with any level of 1 - 5, the following
message appears:
The ’health-override’ option is only used
with the ’interchange’ level