Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-266 Issue 4 May 2002
release tdm
This command removes specified tdm buses from a maintenance busy state.
Output
The following output example is a display of release tdm port-network 1 bus a.
Field descriptions
Action/
Object Qualifier Qualifier Description Logins Defaults
Feature
Interactions
release
tdm
port-
network
pn
number
bus bus
specifies the Port Network number of the
TDM bus to be released.
(“a” or “b”) specifies desired half of the TDM
bus. Each 512 time slot TDM bus is
configured as two duplicate 256 time slot
buses. This division allows for duplication of
control channels and dedicated tone time
slots. The default control bus (carrying the
control channel) is the “a” bus, while the
default tone bus (carrying dedicated tones) is
the “b” bus. (1 - 3)
Examples:
release tdm port-network 1 bus a
release tdm port-network 1 bus b
init
inads
craft
none System tears
down busied
out buses.
No new calls
can be
administered
on busied
out buses
Port
Port network number (preceded by “PN”) and bus (“A” or
“B”) associated with the TDM bus.
Maintenance Name
TDM-BUS
Alt. Name
Not applicable.
Result
Success status of a busied out object (PASS, ABORT,
FAIL)
Error Code
System-generated description of a command failure.
release tdm port-network 1 bus a
COMMAND RESULTS
Port Maintenance Name Alt. Name Result Error Code
PN 01A TDM-BUS PASS
Command successfully completed
To Next Page
Loading...
