Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-112 Issue 4 May 2002
test access-endpoint
Help Messages
If the user presses HELP after entering “test access-endpoint”, the following
message appears:
Enter extension number, [’long’ or ’short’],
[’repeat’ (1-100)], [’schedule’]
Error Messages
If the format for the extension is incorrect, the following error message appears:
Extension invalid
If the EPN on which the access endpoint resides is not accessible, the following
message appears:
EPN is not available
If the extension is not administered, the following message appears:
Extension not assigned
If the object associated with the specified extension is not an access endpoint, the
following message appears:
Extension assigned to object
other than access-endpoint
If the board that contains the access endpoint is not inserted in the system, the
following message appears:
Board not inserted
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
To Next Page
Loading...
