Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-56 Issue 4 May 2002
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy, try again later
monitor bcms
Help Messages
If the system technician presses HELP after entering “monitor bcms”, the
following object command word choices appears:
Please enter one of the following object command words:
skill split system
Or press CANCEL to cancel the command
If the system technician presses HELP after entering “monitor bcms system” the
following message appears:
Enter [measured split numbers separated by one space
and/or split range in the format xx-xx], [’print’]
Or press CANCEL to cancel the command
If the system technician presses HELP after entering command “monitor bcms
split” or “monitor bcms skill” the following message appears:
Enter a measured split or skill number(1-99), [’print’]
Or press CANCEL to cancel the command
Error Messages
If the split or skill number entered is non numeric, not administered, or invalid in
any other way, the following message appears:
Invalid split number
If the split or skill number entered is not measured by BCMS or only measured
externally, the following message appears:
Split is not measured by Basic Call Management System (BCMS)
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
To Next Page
Loading...
