Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-238 Issue 4 May 2002
netstat ip-route
Use netstat ip-route to display routing tables that are resident in the C-LAN and
VAL circuit packs. Use the “board” option (
netstat ip-route board UUCss) to
display the routing tables that are resident on a specific C-LAN or VAL board.
Output
The following example shows the output from netstat ip-route.
Service State
In-service/active, in-service/idle, out-of-service, out-of-service-NE
(Near End), out-of-service-FE (Far End), maint-NE/active,
maint-FE/active, maint-NE/idle, maint-FE/idle,
pending-in-service, pending-maint, or disconnected.
NE (Near End) and FE (Far End) refer to the “end” of the trunk
that has placed the facility in its current state.
Maintenance
Busy
This field identifies maintenance testing that occurs on the trunk.
CA-TSC State
The state of temporary signaling connections. (connection set up
to pass call information over PRI signaling links).
Action/
Object Qualifier Qualifier Description Logins Default
Feature
Interactions
netstat
ip-route
board
UUCss
Example:
netstat ip-route board 01A03
init
inads
craft
none none
netstat ip-route Page 1 of x
IP ROUTING
Bd/Pt Destination Gateway Subnet Mask Interface
01E0517 0.0.0.0 172.17.17.254 0.0.0.0 cpm0
01E0518 127.0.0.1 127.0.0.1 255.255.255.255 1o0
01B0907 172.17.17.165 172.17.17.165 255.255.255.255 ppp6
01B1233 0.0.0.0 0.0.0.0 0.0.0.0 motfec0
01B1218 127.0.0.1 127.0.0.1 255.255.255.255 1o0
To Next Page
Loading...
