display errors
Issue 4 May 2002
A-39 555-233-123
display errors
Help Messages
If the technician presses HELP after entering “display errors” the following
message appears:
[’high-resolution’], [’print’ or ’schedule’]
Error Messages
If the software data cannot be sent to the SAT, the following message appears:
Error encountered, can’t complete request
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
Field Help
Following are the help messages that the system technician will see upon tabbing
to the specified field and pressing the
HELP key.
Category: “”xxxxxxxx” is an invalid entry; please press HELP”
Extension: "Entry must be all digits"
Trunk (group) "Entry must be all digits"
Trunk (member) "Entry must be all digits"
Error Type: "Enter error type"
Error List: The Error List field help provides the following help list: active-alarms, errors,
cleared-errors.
Interval: The interval field help provides the following help list: h(our), d(ay), w(eek),
m(onth), a(ll).
From (month) "Enter month between 1-12"
From (day) "Enter day between 0-31"
From (hour) "Enter hour between 0-23"
From (minute) "Enter minute between 0-59"
To (month) "Enter month between 1-12"
To (day) "Enter day between 0-31"
To Next Page
Loading...
