Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-74 Issue 4 May 2002
If the specified cabinet carrier location is that of a switch node, the following
message appears:
Switch Node carrier specified;
invalid command for SN carrier
If the cabinet carrier location entered is that of an EPN that is not available, the
following message appears:
EPN is not available
If the tone/clock is not busied out and the specified action is release, the following
message appears:
Object is not busied out; can’t release
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
release trunk
Help Messages
If the system technician presses HELP after entering “release trunk,” the following
message appears:
Enter assigned trunk group number [or group/member]
Error Messages
If the format of the identifier is invalid, the following message appears:
Format invalid
If the range of the trunk group is incorrect, the following error message appears:
Trunk or trunk group invalid
To Next Page
Loading...
