Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-88 Issue 4 May 2002
set tdm
Help Messages
If the system technician presses HELP after entering “set tdm,” the following
message appears:
Enter ’port-network’, port network number (1-3),
’bus’, bus (’a’ or ’b’); [’override’]
Error Messages
If the technician enters “bus” before “port-network,” the following message
appears:
’bus’ is an invalid identifier; please press
HELP
If the technician does not enter all digits for the port-network number, the following
message appears:
Entry must be all digits
If the technician enters a bus other than A or B, the following message appears:
Identifier invalid
If the technician enters a Port Network number that is not administered, the
following message appears:
Port Network number not assigned
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
To Next Page
Loading...
