Avaya Definity SI - CARD-MEM (Memory Card)

CARD-MEM (Memory Card)
Issue 4 May 2002
10-341 555-233-123
CARD-MEM (Memory Card)
This maintenance object monitors the flash memory of the system. A memory
card contains a set of flash EPROM memory devices. The memory card stores
data that can remain nonvolatile, even when the power is off. The memory card is
on the TN777B Netcon and TN2401/TN794 NetPkt circuit pack to save
■ Translations
■ Announcements
■ Core dumps
— Saves maintenance hardware error logs
— LMM applies update file to in-core system software.
The memory card does not contain a copy of the system software.
The recommended size of a memory card for each configuration is described in
the following table.
NOTE:
Beginning with Release 9, the memory card has no write-protect switch and
no equivalent software mechanism.
Software erase and write operations on a memory card take longer as the card
usage increases. Replace memory cards that software cannot erase or write to.
MO Name (in
Alarm Log) Alarm Level Initial Command to Run Full Name of MO
CARD-MEM MAJOR
1
1The “MAJOR” alarm occurs only at power-up time or on a Reset System 3, 4, or 5
when the switch cannot load all translations from the memory card.
Memory Card
CARD-MEM MINOR test card-mem long Memory Card
CARD-MEM WARNING test card-mem sh Memory Card
Memory Card Size Usage File Names
8 Megabyte With Announcements translation/announcements
16 Megabyte DEFINITY Wireless
Business System
translation/announcements/
firmware
48 Megabyte System Upgrade
Note: post-G3V8
translation announcements/
core_dump
48 Megabyte System Upgrade
Note: post-G3V8
system_software