netstat arp
Issue 4 May 2002
8-239555-233-123
Field descriptions
netstat arp
Use this command to:
■ display the contents of the C-LAN circuit pack’s Address Resolution
Protocol (ARP) table
■ help troubleshoot, isolate, and correct duplicate IP addresses within the
network.
Board/Pt
The location of the circuit pack that provides the interface for the
route.
Destination
Display-only field showing the IP address of each route’s destination.
The Destination is administered on the Node Name screen.
On the Node Name screen, “Default” in the Destination field
administers the default route.
Gateway
Display-only field showing the IP address of the Gateway used to
reach the Destination. A Gateway is administered on the Node Name
screen.
Subnet Mask
Display-only field showing the subnet mask information entered on
the IP Interfaces screen.
Interface
■ pppn represents one of the PPP interfaces on the C-LAN, which
is administered as port n+1.
■ cpm0 represents the ethernet interface on the C-LAN which is
administered as port 17.
■ motfec0 represents the ethernet interface on the VAL circuit
pack, which is administered as port 33.
■ lo0 represents the loopback interface on the circuit pack (C-LAN
or VAL) which does not need to be administered.
Action/
Object Qualifier Qualifier Description Logins Default
Feature
Interactions
netstat-
arp
unsorted
ip-sorted
mac-sort
ck-dup
Displays data in the order it was
received.
Displays data sorted by IP address
Displays data sorted by MAC address
Displays entries that contain duplicated
IP addresses.
init
inads
craft
station and
trunk MSP
permissions
To Next Page
Loading...
