Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-16 Issue 4 May 2002
Error Messages
If there is no “test hardware-group” command currently active to be canceled, the
following message appears:
Command aborted - no hardware-group test in progress
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
change circuit-packs
Help Messages
If the system technician presses HELP after entering “change circuit-packs” the
following message appears:
Enter number between [1-3]
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If an invalid cabinet number is entered on the command line the following
message appears:
“n” Identifier not assigned
To Next Page
Loading...
