status logins
Issue 4 May 2002
A-103 555-233-123
status logins
Help Messages
If the technician presses HELP after entering “status logins” the following message
appears:
[’print’]
Error Messages
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
status mst
Help Messages
If you press HELP after entering “status mst”, the following message displays:
Entry is not required
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
To Next Page
Loading...
