Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-82 Issue 4 May 2002
save announcements
Help Messages
If the system technician presses HELP after entering “save announcements” on a
simplex SPE system the following message appears:
Entry is not required
If the system technician presses
HELP after entering “save announcements” on a
duplex SPE system the following message appears:
Enter [’spe-active’ or ’spe-standby’]
Error Messages
If the announcement data module cannot be accessed (upload/download port is
active), the following message appears:
Announcement data module not available
If the announcement data module is out of service, the following message
appears:
Announcement data module out of service
If one or more of the announcement ports are in use, the following message
appears:
Announcement port in use; please try later
If there are no announcements on the announcement board, the following
message appears:
No announcements on board
If the announcement data module is not administered, the following message
appears:
Required announcement data module not administered
If the announcement data module is not administered or is currently in use, the
following message appears:
Required data module not administered or unavailable
If there is no announcement board in the system, the following message appears:
Integrated announcement board not present
If the standby processor times out, the following message appears:
Command timed out on standby processor
To Next Page
Loading...
