status tti
Issue 4 May 2002
A-111 555-233-123
If the specified signaling group is not administered, the following message
appears:
No signaling group assigned
If the specified signaling group has no TSC assigned or the specified TSC is
unadministered, the following message appears:
No TSC assigned
If the specified TSC number is out of range, the following message appears:
Tsc index invalid
If the software data cannot be sent to the SAT, the following message appears:
Error encountered, can’t complete request
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
status tti
Help Messages
If the system technician presses HELP after entering “status tti”, the following
message appears:
[’print’]
Error Messages
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit.
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later.
To Next Page
Loading...
