Avaya Definity SI - Clear Mst; Clear Pkt; Clear Port

Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-32 Issue 4 May 2002
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
clear mst
Help Messages
If HELP is pressed after entering “clear mst,” the following message appears:
Entry is not required
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. A conflict could occur if another user was executing an
enable, disable or clear message sequence trace command at the same time.
The message is as follows:
’login id’:’command’ has a command conflict
clear pkt
Help Messages
If the technician presses HELP after entering “clear pkt,” this message displays:
Enter port-network; port network number (1-3)
Error Messages
If the packet bus is not administered, this message displays:
Packet Bus is not activated, check system-parameters maintenance form
If all available maintenance resources are in use, this message displays:
All maintenance resources busy; try again later
clear port
Help Messages
If the system technician presses HELP after entering “clear port,” the following
message appears:
Enter 7 character port number