Maintenance Object Repair Procedures
555-233-123
10-412 Issue 4 May 2002
CLSFY-PT (Call Classifier Port)
The TN744 Call Classifier (CLSFY-BD) circuit pack is a service circuit pack that
enables usage of the Outbound Call Management (OCM) and the Inbound Call
Management (ICM) features. On a G3iV2-386 system, the TN744 also enables
usage of R2-MFC signaling for incoming and outgoing feature operation. There
are eight ports (CLSFY-PTs) on the Call Classifier circuit pack. Each port can
handle call classification, touch-tone reception, or, for G3iV2-386 systems, MFC
tone generation and detection or touch-tone reception.
The CLSFY-PT maintenance feature defines a set of tests to ensure that the Call
Classifier circuit pack ports are capable of detecting tones for call classification,
and detecting and generating necessary tones for correct MFC feature operation.
Hardware Error Log Entries and Test to Clear
Val ues
MO Name (in
Alarm Log)
Alarm
Level Initial Command to Run
1
1 Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier designation (e.g.,
A, B, C, D, or E); SS is the address of the slot in the carrier where the circuit pack is located (e.g.,
01, 02, etc.); and pp is the 2-digit port number (e.g., 01).
Full Name of MO
CLSFY-PT(a) MAJOR test port PCSSpp sh Call Classifier Port Maintenance
CLSFY-PT MINOR test port PCSSpp sh Call Classifier Port Maintenance
CLSFY-PT WARNING release port PCSSpp Call Classifier Port Maintenance
Table 10-154. Call Classifier Port (CLSFY-PT) Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
1 any Tone Detector
Audit/Update Test
(#43)
MAJOR/
MINOR (a)
ON test port PCSSpp r 2
18 Port has been
busied out by
system technician
WARNING OFF release port PCSSpp
257 (b) 17666 Test (#43) MAJOR/
MINOR(a)
ON test port PCSSpp r 3
513 (c) any Tone Detection
Verification Test
(#42)
MAJOR/
MINOR (a)
ON test port PCSSpp r 3
Continued on next page
To Next Page
Loading...
