test analog-testcall
Issue 4 May 2002
8-417555-233-123
test analog-testcall
The test analog-testcall command performs facility diagnostic tests on an entire
trunk group, an individual trunk group member, an individual trunk port or on all
trunks on a board, depending on the options entered. The type of test call, the
far-end test line number, and the various other parameters must be administered
on the trunk group form before executing the command. Normally, the user should
only invoke the full or supervision test. The other options are provided primarily for
testing when setting up an ATMS schedule.
Date
Alarmed
Day, hour, and minute of alarm.
Alarm Count
Count of the current alarm entry versus the total number of alarms
to be tested.
Test results section
Port
Port address (cabinet-carrier-slot-circuit)
Maintenance
Name
The name of maintenance object
Alt. Name
Alternate way to identify maintenance objects.
If the Object is The field contains
station extension
trunk xxx/yyy (xxx = trunk group, yyy = member)
private CO line P/xxx (xxx = private CO line group number)
Test No
The test being executed
Result
Test result: Fail, Pass, Abort, or No Board. If this field has conflict,
another user may be testing this hardware. If this field has
epn-down, the epn is inaccessible at this time.
Error Code
Numeric code explaining why the release failed or aborted. Refer
to the detailed list of the codes by test number for each MO.
To Next Page
Loading...
