test pri-endpoint
Issue 4 May 2002
8-473555-233-123
test pri-endpoint
This command performs hardware diagnostic tests on all port circuits
(B-channels) that are associated with the PRI endpoint extension.
The test pri-endpoint command performs hardware diagnostic tests on all port
circuits (B-channels) that are associated with the specified PRI endpoint.
Action/Object Qualifier Qualifier Description Logins Defaults
Feature
Interactions
test
pri-endpoint
extension
short
long
repeat
number
clear
schedule
PRI endpoint extension to be
tested (must conform to dial-plan)
Option for a brief series of
nondestructive diagnostic tests.
Option for a longer, more
comprehensive series of both
destructive and nondestructive
diagnostic tests.
How many times each test in the
sequence is repeated (1-100)
This option causes the test
sequence (short or long) to repeat
until the alarm (if any) is cleared or
a single test in the sequence fails.
1
Command is validated and then a
scheduling form displays to
schedule execution of the
command. The command is then
placed in the command queue and
is executed at the specified time.
The information displayed by the
command is sent to the system
printer instead of the screen.
2
Examples:
test pri-endpoint 25012
test pri-endpoint 45002 sh
test pri-endpoint 45892 l
test pri-endpoint 24389 sh r 4
test pri-endpoint 34899 l r 6
test pri-endpoint 34912 l r 5
schedule
test pri-endpoint 93483 r 2
test pri-endpoint 10022 c
test pri-endpoint 92349 schedule
1 If no alarms are registered against the maintenance object then the test sequence is run only once. The long
clear option forces a clear of all alarms if no errors are encountered during testing. The short clear option only
clears alarms pertinent to tests in the short sequence.
2 Refer to the Report Scheduler and System Printer feature specification for more details.
init
inads
craft
nms
Test
Sequence
= short;
Repeat = 1
none
To Next Page
Loading...
