Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-98 Issue 4 May 2002
Error Messages
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
status cleared-alarm-notif
Help Messages
[‘1’ or ‘2’]
status data-module
Help Messages
If the system technician presses HELP after entering “status data-module”, the
following message appears:
Enter assigned extension, [’print’]
Error Messages
If the format of the extension is incorrect, the following error message appears:
Extension invalid
If the extension is not administered, the following message appears:
Extension not assigned
If the object associated with the extension is not a data module, the following
message appears:
Extension exists but assigned to a different object
If software fails to complete the command, one of the following messages
appears:
No tests for this MO
EPN is not available
Board not assigned
Port not assigned
Error encountered, can’t complete request
To Next Page
Loading...
