test alarms
Issue 4 May 2002
A-113 555-233-123
test alarms
Help Messages
If the technician presses HELP after entering “test alarms” the following message
appears:
Enter [’auto-page’], [’failures’], [’step’],
[’short’ or ’long’], [’repeat’ (1-100) or ’clear’]
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy;
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
Field Help
Following are the help messages that the system technician will see upon tabbing
to the specified field and pressing the HELP key.
Major? "n(o) y(es)"
Minor? "n(o) y(es)"
Warning? "n(o) y(es)"
Interval: "m(onth), h(our), d(ay), w(eek), a(ll)"
From month "Enter month between 1-12"
From (day) "Enter day between 0-31"
From (hour) "Enter hour between 0-23"
From (minute) "Enter minute between 0-59"
To (month) "Enter month between 1-12"
To (day) "Enter day between 0-31"
To (hour) "Enter hour between 0-23"
To (minute) "Enter minute between 0-59"
Cabinet: "Enter cabinet number (1-3)"
To Next Page
Loading...
