Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-114 Issue 4 May 2002
Field Error Messages
Following are the error messages that appears on the screen. The messages
display when the system technician tabs out of a field and the validation routines
are executed. In the following messages, an “x” represents the character that was
entered by the user.
Port Network: "Enter port network number (1-3)"
Board Number: "Enter 4 character board number;
[cabinet(1-3)]:carrier(A-E):slot(0-21)"
Port: "Enter port number;
[cabinet(1-3)]:carrier(A-E):slot(0-21):circuit(1-24)"
Category: “adm-conn, announce, bri/asai, card-mem, cdr, data-mod,
detector, dup-spe, environ, ext-intf, ext-dev, generatr, inads-link,
infc, maint, mbus, memory, misc, mnt-test, modem, netcon, pkt,
pkt_ctrl, quick-st, pms/jrnl, procr, s-syn, stabd, stacrk, stations,
sys-prnt, tape, tdm, tone, trkbd, trkcrk, trunks and wideband” (For
a table describing the category entries in greater detail, see the
“display errors” command.)
Extension: "Enter assigned extension, or blank"
Trunk (group) "Enter group number between 1-99"
Trunk (member) "Enter group member between 1-99, or blank"
Major? ""x" is an invalid entry; please press HELP"
Minor? ""x" is an invalid entry; please press HELP"
Warning? ""x" is an invalid entry; please press HELP"
Interval: ""x" is an invalid entry; please press HELP key"
From (month) "Entry must be all digits"
From (day) “Entry must be all digits”
“Day invalid”
From (hour) “Entry must be all digits”
“Hour invalid”
From (minute) “Entry must be all digits”
“Minute invalid”
To (month) "Entry must be all digits"
To (day) “Entry must be all digits”
“Day invalid”
To (hour) “Entry must be all digits”
“Hour invalid”
To (minute) “Entry must be all digits”
“Minute invalid”
Cabinet: "Invalid entry"
To Next Page
