release packet-control
Issue 4 May 2002
A-67 555-233-123
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then
resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
release packet-control
Help Messages
If the system technician presses HELP after entering “release packet-control,” the
following message appears:
Enter Packet Control location: [cabinet(1)];carrier(A-B)
Error Messages
If this command is entered for a packet-control that resides on the stand-by
control complex of a High or Critical Reliability System, the following message
appears:
Command only applies to the active Packet Control
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then
resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
All maintenance resources busy; try again later
To Next Page
Loading...
