display system-parameters duplication
Issue 4 May 2002
8-111555-233-123
display system-parameters duplication
This command displays the status (enabled or disabled) of Switch Processing
Element (SPE) and Port Network Connectivity (PNC) duplication. The following
must be duplicated:
■ Each switch node record and every switch node with its duplicate (cabinet
administration is a prerequisite)
■ Every fiber link containing either an expansion interface circuit pack as an
endpoint, or a DS1-C (fiber link administration is a prerequisite; circuit pack
administration then follows duplication administration)
All nonduplicated switch node interfaces (SNI) to SNI fiber links are automatically
duplicated.
NOTE:
The PNC Duplication field must be enabled on the customer options form
before you can do any duplication administration.
PNC Duplication cannot be enabled until all pnc-a and pnc-b boards are
released from the “busyout” state.
Output
The following example shows the output from display system-parameters
duplication.
Screen 8-12. Duplication-Related System Parameters form (page 1 of 1)
Action/
Object Qualifier
Qualifier
Description Logins Defaults
Feature
Interactions
display
system-
parameters
duplication SPE or PNC
duplication
Examples:
display system-
parameters
duplication
init
inads
craft
none none
Page 1 of 1
DUPLICATION-RELATED SYSTEM PARAMETERS
Enable Operation of SPE Duplication? y
Enable Operation of PNC Duplication? y
To Next Page
Loading...
