Avaya Definity SI - Page 2842

Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-38 Issue 4 May 2002
Field Error Messages
Following are the error messages that appears on the screen. The messages are
displayed when the system technician tabs out of a field and the validation
routines are executed. In the following messages, an “x” represents the character
that was entered by the user.
Board Number: "Enter 5 character board number;
cabinet(01-3):carrier(A-E):slot(00-20)"
Port: "Enter port number;
[cabinet(1-3)]:carrier(A-E):slot(0-20):circuit(01-31)"
Category: The category field help is a list of objects. This list includes the
following: adm-conn, announce, bri/asai, card-mem, cdr,
data-mod, detector, dup-spe, environ, exp-intf, ext-dev, generatr,
inads-link, infc, maint, mbus, memory, misc, mnt-test, modem,
netcon, pkt, pkt-ctrl pms/jrnl, procr, quick-st s-syn, stabd, stacrk,
stations, sys-prnt, tape, tdm, tone, trkbd, trkcrk, trunk, wideband.
For a table describing the category entries in greater detail, see
the ‘‘display errors’’ command.
Extension: “Enter assigned extension”
Trunk (group) "Enter group number between 1-99"
Trunk (member) "Enter group member between 1-99, or blank"
Active? ""x" is an invalid entry; please press
HELP"
Resolved? ""x" is an invalid entry; please press
HELP"
Major? ""x" is an invalid entry; please press
HELP"
Minor? ""x" is an invalid entry; please press HELP"
Warning? ""x" is an invalid entry; please press
HELP"
Interval: ""x" is an invalid entry; please press
HELP"
From (month) "Entry must be all digits"
From (day) "Entry must be all digits"
From (hour) "Entry must be all digits"
From (minute) "Entry must be all digits"
To (month) "Entry must be all digits"
To (day) "Entry must be all digits"
To (hour) "Entry must be all digits"
To (minute) "Entry must be all digits"
Cabinet: "Entry invalid"
Port Network: "Entry invalid"
Board Number: "Board invalid"
Port: "Port invalid"