Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-220 Issue 4 May 2002
Screen 8-16. List trace screen (list trace station)
list trace tac
Use this command to see the VPI.VCI data for a specified trunk. The command
syntax for ATM-specific trace data is list trace tac xxx/a, where
■ xxx is the trunk access code number.
■ /a means that you are requesting ATM-specific data.
Field descriptions (list trace)
Time The system time that the event in the data field occurred
Data A description of the event:
setup indicates a successful ATM setup
fail indicates an unsuccessful ATM setup or the network released an SVC
after setup
rele(ase) DEFINITY has sent an SVC-release message (This is unlikely
because the call being traced has already ended by the time the
SVC-release message is sent.)
add indicates that a party has been added to an SVC
rej(ect) indicates a rejected ATM-EI add-party message
drop indicates that DEFINITY sent an SVC drop-party message.
save indicates that an SVC has been saved in the DEFINITY ATM cache
reuse indicates that an SVC in the DEFINITY ATM cache has been reused
list trace station 52501/a Page 1 of 1 SPE B
LIST TRACE
Time Data
15:12:07 Calling party station 57405 cid 0x20
15:12:09 dial 52501
15:12:09 ring station 52501 cid 0x20
15:12:09 ATM setup PN01-0081 to PN03-0045
15:12:09 ATM setup PN03-0046 to PN01-0082
15:12:11 active station 52501 cid 0x20
15:12:22 idle station 57405 cid 0x20
To Next Page
Loading...
