Avaya S8300 - Page 13

Pre-upgrade service pack requirements
Issue 2 June 2005 13
On the ICC/LSP
7. If IA770 is installed, get
IA770 data and stop
IA770.
Page 225.
8. Install pre-upgrade
software service pack,
if necessary
Page 233.
See Pre-upgrade service pack requirements
on
page 10
9. Perform data backup.
Pages 229 and 235.
Backup according to the release from which you
are upgrading. See Pre-upgrade service pack
requirements on page 10
You will not restore these data sets. It is important
to have them in case it is necessary to revert to
the original configuration.
10. Record configuration
information.
Page 226.
If you have not already done so, in the Record
Configuration Information task, record all of the
configuration information, regardless of the
release from which you are upgrading.
You will re-enter some of this information after the
upgrade.
11. Replace the S8300A
with the S8300B, if
necessary.
Page 238.
● Shut down the S8300A.
● Remove the S8300A from the gateway. (If
the gateway is a G700, the LED panel
must be removed together with the
S8300A.)
● Re-insert the S8300B (together with the
LED panel for a G700) into the gateway.
12. Upgrade the S8300B.
Starting on page 239,
ending on page 250.
● Set Telnet parameters
● Remaster hard drive and install upgrade
software
● Select No on Install AUDIX screen.
● Verify software version
● Copy files to the S8300B (license file,
authentication file, service pack file)
Task Steps/Comments