Avaya S8300 - Page 22

Converting an S8300 from LSP to ICC and upgrading Communication Manager from 1.x to 2.x
22 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
9. Replace the S8300A
with the S8300B, if
necessary.
Page 238.
If upgrading to CM2.2
or earlier, and using
IA770, move the
CWY1 board from the
S8300A to the
S8300B.
● Shut down the S8300A.
● Remove the S8300A from the gateway. (If
the gateway is a G700, the LED panel
must be removed together with the
S8300A.)
● Install the CWY1 board on to the S8300B.
See Job aid: Replacing the S8300 Media
Server or its Hard Drive, 555-245-753,
Issue 2, June 2004.
● Re-insert the S8300B and CWY1 board
(together with the LED panel for a G700)
into the gateway.
10. Upgrade the S8300B.
Starting on page 239,
ending on page 250.
● Set Telnet parameters
● Remaster hard drive and install upgrade
software
● If using IA770, select yes on Install
AUDIX screen
● Verify software version
● Copy files to the S8300 (license file,
authentication file, service pack file)
11. Restore data
Page 251.
Select the restore procedure according to the
release from which you upgraded.
12. Set time, date, and
time zone.
Page 259.
The time zone of the new ICC must be set, and
all LSPs under the ICC’s control must be set to
the new ICC’s time zone.
13. Install post-upgrade
service pack file, if any.
Page 260.
14. Install the LSP license
file.
Starting on page 263.
15. Install the
authentication file.
Starting on page 264.
Task Steps/Comments