Pre-upgrade service pack requirements
Issue 2 June 2005 25
On the ICC
27. Verify LSP status (if
any)
● At the ICC’s SAT prompt, enter display
lsp. The LSP names and IP addresses (if
any) should be listed. The Service State?
field should be in-service/idle.
● The Translations Updated should match
the translations date and time on the ICC.
To view the ICC’s translations date and
time, enter list configuration
software.
28. If the LSPs (if any)
translations have not
synchronized with the
ICC, invoke translation
synchronization.
● On the ICC, enter the Linux command
filesync -l trans.
● Ensure that the translation synchronization
completed successfully. Wait several
minutes, then check the timestamp of the
LSP’s translation files using the SAT
command display lsp on the ICC.
Post-upgrade tasks
29. Implement any
additional design
changes to voice and/
or voice messaging
networks.
Task Steps/Comments
To Next Page
Loading...
