Avaya S8300 - Page 33

Issue 2 June 2005 33
On the LSP’s primary controller
19. Verify LSP status.
● At the SAT prompt, enter display lsp. The LSP
host name and IP address should be listed. The
Service State? field should be in-service/
idle.
● The Translations Updated should match the
translations date and time on the primary
controller. To view the primary controller’s
translations date and time, enter list
configuration software.
20. If the LSP’s translations
have not synchronized
with the primary
controller, invoke
translation
synchronization.
● On the primary controller, enter the Linux
command filesync -a ipaddress
where ipaddress is the IP address of the LSP.
● Ensure that the translation synchronization
completed successfully. Wait several minutes, then
check the timestamp of the LSP translation files
using the SAT command display lsp on the
primary controller.
Post-upgrade tasks
21. Implement any additional
design changes to voice
and/or voice messaging
networks.
22. Re-register the S8300B
as an LSP with the Avaya
remote servicing center.
Task Steps/Comments