Avaya S8300 - Page 42

Converting an S8300 from LSP to ICC and upgrading Communication Manager from 2.0.x to 2.x
42 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
21. Remove endpoints
from the current
primary controller that
will be controlled by
the new ICC.
● Remove endpoints from the current
primary controller.
On LSPs of the new ICC (if any)
22. Reboot LSPs (if any) At the LSP’s SAT prompt, enter reset system
4.
23. Verify LSP translations
date and time (if any).
To view the LSP’s translations date and time,
enter list configuration software.
On the ICC
24. Verify LSP status (if
any)
● At the ICC’s SAT prompt, enter display
lsp. The LSP name and IP address
should be listed. The Service State? field
should be in-service/idle.
● The Translations Updated should match
the translations date and time on the ICC.
To view the ICC’s translations date and
time, enter list configuration
software.
25. If the LSPs (if any)
translations have not
synchronized with the
ICC, invoke translation
synchronization.
● On the ICC, enter the Linux command
filesync -a trans.
● Ensure that the translation synchronization
completed successfully. Wait several
minutes, then check the timestamp of the
LSP’s translation files using the SAT
command display lsp on the ICC.
26. Upgrade the gateway
Firmware.
Start on page 267.
● Using the Avaya Installation Wizard on the
new ICC to upgrade the gateway firmware
is recommended.
● Alternatively, you can use the gateway’s
MGP CLI commands starting on page 144.
Task Steps/Comments