Avaya S8300 - Page 58

Converting an S8300 from LSP to ICC (Communication Manager 2.1 or later)
58 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
On the ICC
25. Verify LSP status (if
any)
● At the ICC’s SAT prompt, enter display
lsp. The LSP name and IP address
should be listed. The Service State? field
should be in-service/idle.
● The Translations Updated should match
the translations date and time on the ICC.
To view the ICC’s translations date and
time, enter list configuration
software.
26. If the LSPs (if any)
translations have not
synchronized with the
ICC, invoke translation
synchronization.
● On the ICC, enter the Linux command
filesync -a trans.
● Ensure that the translation synchronization
completed successfully. Wait several
minutes, then check the timestamp of the
LSP’s translation files using the SAT
command display lsp on the ICC.
Post-conversion tasks
27. Implement any
additional design
changes to voice and/
or voice messaging
networks.
Task Steps/Comments