avenli SPA3 - Spa Storage and Repair; Troubleshooting; Valve Repair and Common Issues

Storage
• Press the bubbling button to blow out the water inside the jet holes. Unplug the
pump, remove the filter cartridge from the inner wall of the pool.
• Use a towel to wipe off the pool, dry 24 hours.
• Push the valves to deflate the pool.
• Fold the pool.
It is recommended that store the SPA in its original package in a warm dry place.
Repair kit
Little holes or puncture can be repaired with the repair kit included and glue reserved to
pool liner.
• Find the leak.
• Thoroughly clean the area surrounding the leak.
• Cut a piece of repair material in round shape, which should be larger than the
damaged area.
• Apply adhesive to the underneath side of the patch and around the area to be
repaired.
• Put the patch on the damaged area and press down firmly. Allow 12 hours for repair
to dry. After patch has dried, apply glue around the edges for a complete seal (dry 4
hours).
Trouble shooting
If air valve damages or leaks, please replace valve according to the steps followed.
Directly press down
spring inside valve to
deflate.
Use tools to
unscrew air valve
spindle.
Replace a new air
valve spindle.
Tighten the air valve
by tools.