aventon Pace 350 V2 - User Manual

Questions and Answers

C
Christian FordAug 11, 2025
Why my aventon Pace 350 V2 Bicycle does not work?
- G
  gonzalezkatherineAug 11, 2025
  Your Aventon Bicycle might not be working due to several reasons: the battery may not have sufficient power, so you should charge it; there might be faulty connections, in which case you should clean and repair the connectors; the battery might not be fully seated in the tray, so ensure it is correctly installed; the turn-on sequence might be incorrect, so follow the proper sequence; or the brakes might be applied, so disengage them.
J
Justin HubbardAug 16, 2025
How to improve the range of my aventon Pace 350 V2?
- D
  derrick44Aug 16, 2025
  To improve the range of your Aventon Bicycle, consider the following: ensure your tires have adequate pressure by adjusting it; check the battery connections or charge the battery if it's low or faulty; if you're frequently encountering hills, headwinds, braking, or carrying excessive loads, assist with the pedals or adjust your route; and make sure the brakes aren't rubbing by adjusting them.
R
Ryan CarterAug 20, 2025
What to do if my Aventon Bicycle battery will not charge?
- T
  Tiffany LongAug 21, 2025
  If your Aventon Bicycle battery won't charge, check that the charger is well connected by adjusting the connections. If the connections are fine, the charger, battery, or wiring may be damaged, consider replacing or repairing them.
F
fsmithAug 25, 2025
Why does my aventon Pace 350 V2 have irregular acceleration?
- P
  Paul GouldAug 26, 2025
  Irregular acceleration or reduced top speed in your Aventon Bicycle can be due to insufficient battery power, so charge or replace the battery. Another cause might be a loose or damaged throttle, which would need replacement. Lastly, check if the magnet ring is misaligned or damaged, and align or replace it as necessary.
J
James HernandezAug 30, 2025
What to do if the motor doesn't respond on my aventon Pace 350 V2?
- M
  marksimpsonAug 30, 2025
  If the motor on your Aventon Bicycle doesn't respond when powered on, it could be due to loose wiring, which you should repair or reconnect. Another potential cause is a loose or damaged throttle, which you should tighten or replace. Also, check for a loose or damaged motor plug wire and secure or replace it. In the event of damaged motor, repair or replace it.
T
Tiffany CantuSep 5, 2025
How to fix strange noises from the wheel or motor of my aventon Pace 350 V2?
- B
  bakerrobertSep 5, 2025
  Strange noises from the wheel or motor of your Aventon Bicycle can be caused by loose or damaged wheel spokes or rim, which require tightening, repair, or replacement. Another cause can be loose or damaged motor wiring, which requires reconnection or motor replacement.